Cisco GS7000 Installation And Operation Manual page 151

For EDR 2:1 Transmitter Module
LED Warning
PWR LSR
OFF OFF
Green Orange
(Solid)
Green Orange
(Blink)
Orange Green
(Blink)
Orange Orange
(Blink) (Solid)
Indication
No power supply.
Non-Cisco Standard OPM
Module is installed.
Input Level Overdrive.
Non-Cisco Standard OPM
Module is in use.
Non-Cisco Standard OPM
Module is in use.
Output Level Overdrive.
Troubleshooting
Possible Solutions
PWR
Verify the power supply of the
node with the transmitter
installed.
Verify that connectors of the
transmitter are clicked into the
interface connectors in the
transponder slot.
If still no power supply, contact
the Cisco Technical Service Center
for assistance.
No need for troubleshooting.
Cisco Standard OPM Module is
highly recommended for better
system performance and stability.
See the data sheet of the node for
ordering information.
Verify the input level of RF port 2.
The output level overdrive
indicates the output signal level
exceeds the limit of 35 dBmV.
Verify the input level of RF port 1.
The output level overdrive
indicates the output signal level
exceeds the limit of 35 dBmV.
Verify the input level of RF port 1.
The output level overdrive
indicates the output signal level
exceeds the limit of 35 dBmV.
Cisco Standard OPM Module is
highly recommended for better
system performance and stability.
See the data sheet of the node for
ordering information.
133