Cisco GS7000 Installation And Operation Manual page 95

amplifier assembly's rear panel connectors.
Important: Be careful not to damage the housing with the screwdriver.
5 Grasp the two metal handles on the RF amplifier assembly and carefully lift the
RF assembly out of the housing.
6 To replace the RF amplifier assembly in the housing, carefully align the assembly
in the housing, lower it into place and push down to reconnect the rear panel
connectors.
7 Secure the RF amplifier assembly to the housing with the seven cross-head
shoulder screws.
Important: Tighten the screws in order by number, 1 through 7. Repeat the
sequence twice, ending with a torque of 18 to 20 in-lbs (2.0 to 2.25 Nm).
8 Reinstall the AC power shunts in their proper locations on the RF amp assembly.
Removing and Replacing Modules
77