Mini COOPER CLUBMAN Owner's Manual page 243

Hide thumbs Also See for COOPER CLUBMAN:
Table of Contents

Advertisement

Preparation
NOTE
In the case of body contact between the
two vehicles, a short circuit can occur during
jump-starting. There is a risk of property dam‐
age. Make sure that no body contact
1.
Check whether the battery of the other ve‐
hicle has a voltage of 12 volts. The voltage
information can be found on the battery.
2.
Switch off the engine of the assisting vehi‐
cle.
3.
Switch off any electronic systems/power
consumers in both vehicles.
Starting aid terminals
WARNING
If the jumper cables are connected in the
incorrect order, sparking may occur. There is a
risk of injury. Pay attention to the correct order
during
connection.◀
The starting aid terminal in the engine com‐
partment acts as the battery's positive terminal.
Open the cover of the starting aid terminal.
Breakdown assistance
occurs.◀
Online Edition for Part no. 01 40 2 976 545 - X/16
The body ground or a special nut acts as the
battery negative terminal.
Connecting the cables
1.
Pull off the lid of the starting aid terminal.
2.
Attach one terminal clamp of the positive
jumper cable to the positive terminal of the
battery, or to the corresponding starting aid
terminal of the vehicle providing assistance.
3.
Attach the terminal clamp on the other end
of the cable to the positive terminal of the
battery, or to the corresponding starting aid
terminal of the vehicle to be started.
4.
Attach one terminal clamp of the negative
jumper cable to the negative terminal of
the battery, or to the corresponding engine
or body ground of assisting vehicle.
5.
Attach the second terminal clamp to the
negative terminal of the battery, or to the
corresponding engine or body ground of
the vehicle to be started.
Starting the engine
Never use spray fluids to start the engine.
1.
Start the engine of the assisting vehicle and
let it run for several minutes at an increased
idle speed.
If the vehicle to be started has a diesel en‐
gine: let the engine of the assisting vehicle
run for approx. 10 minutes.
2.
Start the engine of the vehicle that is to be
started in the usual way.
MOBILITY
243

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents