Mini COOPER CLUBMAN Owner's Manual page 186

Hide thumbs Also See for COOPER CLUBMAN:
Table of Contents

Advertisement

DRIVING TIPS
Pulsation of the brake pedal and sounds from
the hydraulic circuits indicate that ABS is in its
active mode.
Objects in the area around the pedals
WARNING
Objects in the driver's floor area can limit
the pedal distance or block a depressed pedal.
There is a risk of an accident. Stow objects in
the vehicle such that they are secured and can‐
not enter into the driver's floor area. Use floor
mats that are suitable for the vehicle and can
be safely attached to the floor. Do not use
loose floor mats and do not layer several floor
mats. Make sure that there is sufficient clear‐
ance for the pedals. Ensure that the floor mats
are securely fastened again after they were re‐
moved, e.g., for
cleaning.◀
Driving in wet conditions
When roads are wet, salted, or in heavy rain,
press brake pedal ever so gently every few
miles.
Ensure that this action does not endanger other
traffic.
The heat generated when braking helps to dry
the brake discs and pads and protect them
from corrosion.
In this way braking efficiency will be available
when you need it.
Hills
WARNING
Light but consistent brake pressure can
lead to high temperatures, brakes wearing out
and possibly even brake failure. There is a risk
of an accident. Avoid placing excessive stress
on the brake
system.◀
WARNING
In idle state or with the engine switched
off, safety-relevant functions, e.g., engine brak‐
ing effect, braking force boost and steering as‐
186
Things to remember when driving
Online Edition for Part no. 01 40 2 976 545 - X/16
sistance, are restricted or not available at all.
There is a risk of an accident. Do not drive in
idle state or with the engine switched
Drive long or steep downhill gradients in the
gear that requires least braking effort. Other‐
wise, the brakes may overheat and reduce
brake efficiency.
You can increase the engine's braking effect by
shifting down, going all the way to first gear, if
needed.
Brake disc corrosion
Corrosion on the brake discs and contamina‐
tion on the brake pads are furthered by the fol‐
lowing circumstances:
Low mileage.
Extended periods when the vehicle is not
used at all.
Infrequent use of the brakes.
Aggressive, acidic or alkaline cleaning
agents.
Corrosion buildup on the brake discs will cause
a pulsating effect on the brakes in their re‐
sponse - generally this cannot be corrected.
Condensation water under the parked
vehicle
When using the automatic climate control, con‐
densation water develops and collects under‐
neath the vehicle.
Ground clearance
NOTE
If ground clearance is insufficient, there
might be contact with the front or rear spoiler,
e.g., when driving over curbs or entering into
underground vehicle parking garages. There is
a risk of property damage. Ensure that there is
sufficient ground clearance
off.◀
available.◀

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents