Power Source - NEC E656 User Manual

Power source

This LCD TV operates on 120 volts 60 Hz, AC current. Insert the power cord
into a 120 volts 60 Hz outlet. The mains plug is used as the disconnect device
and shall remain readily operable.
To prevent electric shock from the TV, do not use with an extension cord,
receptacle, or other outlet unless the blades and ground terminal can be fully
inserted to prevent blade exposure.
Never connect the LCD TV to 50 Hz, direct current, or anything other than the
specified voltage.
CAUTION:
Never remove the back cover of the LCD TV as this can expose you to very
high voltages and other hazards. If the TV does not operate properly, unplug
the LCD TV and call your authorized dealer or service center.
Adjust only those controls that are covered in the instructions, as improper
changes or modifications not expressly approved by NEC could void the
user's warranty.
Batteries installed warning
CAUTION: Incorrect usage of batteries can result in leaks or bursting.
NEC recommends the following battery use:
• Do not mix battery brands.
• Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
• Do not combine new and old batteries. This can shorten the battery life
or cause liquid leakage of the batteries.
• Remove dead batteries immediately to prevent battery acid from leaking
into the battery compartment.
• Do not touch exposed battery acid as it may injure skin.
• Remove the batteries if you do not intend to use the remote control for a
long period of time.
• The batteries shall not be exposed to excessive heat such as sunshine,
fire or the like.
English-6