Battery Installation And Replacement; Connect To The Power Source - NEC E656 User Manual

Battery Installation and Replacement

The remote control is powered by two 1.5V AAA batteries. To install or
replace batteries:
1. Open the battery cover of the remote
control by pushing and pulling it in
the direction of the arrow.
2. Insert two new "AAA" size batteries
for the remote control. When
replacing old batteries, push them
towards the springs and lift them out.
3. Match the batteries to the (+) and (-)
marks in the battery compartment.
4. Insert the bottom of the battery, the
(-) side, into the battery compartment
first, push towards the springs and
insert the top of the battery, the (+)
side, into place. Do not force the
battery into the battery compartment.
5. Close the battery cover making sure
the tabs rest in the corresponding
holes and push down the cover until
it clicks shut.

Connect To The Power Source

The TV should be installed close to an easily accessible power outlet. Fully
insert the prongs into the power outlet socket. A loose connection may cause
image degradation.
If there is power to the TV, the front LED at the bottom of the TV will be either
none or red. A red LED means the TV is in standby mode.
English-18