Right Side Panel Removal - Market Forge Industries 2500 HE Service & Parts Manual

MAINTENANCE
2. Remove panel carefully to avoid damaging connections
WARNING
Controls carry 120 volts Be sure that ex ternal circuit
breaker is shut off before removing panel to avoid
accidental shock or short circuit

6.4.2 Right Side Panel Removal

1. Remove four screws from rear of right side panel
3. Remove six screws from control panel
4. Remove right side panel to gain access to gas valve
and regulator Gas valve and regulator may also be
accessed by removing control panel only
WARNING
Controls carry 120 volts Be sure that external circuit
breaker is shut off before removing panel to avoid
accidental shock or short circuit
6.4.3 Fan Disassembly and Repair
6.4.3.1 Fan Blade Removal
Removal of the fan requires use of a wheel puller kit
(part #99-3334) supplied by Market Forge Wheel puller kit
components are shown in Figure 6-2 To remove fan blade,
proceed as follows
1. Remove fan guard (Fig 7-1,18)
2. Remove Allen head set screws which secure fan to
motor shaft
3. Install wheel puller over hub of fan using Allen head
cap screws
4. Gradually tighten hex bolt on wheel puller until fan
slides off motor shaft
5. Remove wheel puller from fan blade and reinstall
replacement fan on motor shaft as required
6.4.3.2 Fan Motor Removal
Motor removal is completed from inside the oven.
With external circuit breaker shut off, proceed as follows
1. Remove fan guard (Fig 7-1, 18).
Figure 6 2 Wheel Puller Kit Components
2. Remove four nuts (17) and clips (16) from motor
assembly
3. Pull motor forward, carefully disconnect electrical wiring,
and slide motor off screws
4. Install replacement motor assembly as re quired
6.4.4 Burner Pan Removal
1. Remove control panel (See subsection 6.4.1 )
2. Break union below gas valve (Figure 7-2, 35)
3. Remove bottom front louvered panel
4. Disconnect the high voltage lead and the low voltage
lead from their connections at the ignition electrode (25)
and slide the wires out from their respective guides
along the front of the burner pan
5. Remove the two screws (16) that retain man ifold shield
assembly (17) Remove assembly by tipping it forward
and down
6. Remove end seals (10) from burner pan as sembly by
removing screws (18) and prying channels out.
7. Remove manifold retaining bolt (11) and washer(7).
8. Remove screws from front of burner pan as sembly (6).
Slide assembly out.
6.4.4.1 Burner Removal
1. Remove burner pan (See subsection 6.4.4).
2. Pop off retaining clip and slide burner tube (Fig 7-2, 4)
out from manifold.
6-3 S 2207