Section 2 Installation - Market Forge Industries 2500 HE Service & Parts Manual

2.1 RECEIVING
The oven is shipped bolted to a skid and covered by
a carton which is nailed to the skid, these must be
carefully removed prior to installation DO NOT AT ANY
TIME LAY THE OVEN ON ITS TOP, SIDE, OR FRONT
TO DO SO MAY DAMAGE THE EQUIPMENT AND
INVALIDATE THE WARRANTY
2.2 ASSEMBLY
Set-up and assembly procedures for the various oven
configurations are described in the following paragraphs
2.2.1 Oven on 7" (178mm) Stand
1. Screw legs (Figure 2-1, #4) into top frame assem bly
(1)
2. Place into position front and rearchannel as sembly
(2) and side angles (3) These items are loose parts
and are tied together with mounting of oven to stand
Figure 2-1. 7" (178mm) Stand

SECTION 2 INSTALLATION

3. For single oven, mount oven to stand using four
3/8-16 x 3/4 Ig hex head cap screws and four 3/8
plain washers provided
4. For stacked oven, proceed to paragraph 2 2 4
5. For single oven, proceed to subsection 2 3
2.2.2 Oven on Modular Base
1. Screw adjustable feet into cabinet base
2. Mount oven to base using four 3/8- 16 x 3/4 Ig
hex head cap screws and four % plain washers
provided
3. Proceed to subsection 2 3
2.2.3 Oven on 28" (711mm) Open Stand
1. Place top frame (Figure 2-2, #2) upside down on
a clean smooth surface
2. Place into position front and rear angle as-
semblies (8) (stainless only) and legs (1)
3. Align holes in legs, frame, and angle assemblies
Secure using carriage bolts, lockwash-ers, and
nuts provided (5,6,7)
4. Align holes in shelf (3) with leg holes and secure
using hardware (5,6,7)
5. Screw adjustable feet (4) into stand legs
6. Install four clips for oven rack support inside top
frame using hardware (5,6,7) optional
7. Place stand in upright position Install rack
support, if supplied, inserting ends through holes
in clips and shelf
8. Mount oven to stand using four ¾-16 x 3/4 Ig
hex head cap screws and four 3/8 plain washers
provided
9. Proceed to subsection 2. 3
2.2.4 Stack ovens on 7" (178mm) stand
See 2.2.1 for stand assembly and proceed as
Follows:
1. Remove rear panels from both ovens by
removing 14 Phillips head screws from each
rear panel.