Equipment, Tools, And Connections; Items Shipped With Your Router; Connections; Ethernet Devices - Cisco 800M series Installation Manual

Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code,
Section 54). Statement 1052
This product is not intended to be directly connected to the Cable Distribution System. Additional
Warning
regulatory compliance and legal requirements may apply for direct connection to the Cable
Distribution System. This product may connect to the Cable Distribution System ONLY through a
device that is approved for direct connection. Statement 1078

Equipment, Tools, and Connections

This section describes the equipment, tools, and connections necessary for installing the Cisco 800M
Series ISR. It contains the following topics:
•
•
•

Items Shipped with your Router

Unpack the box and verify that all items listed on the invoice are shipped with the Cisco 800M Series
ISR.The following items are shipped with your router:
•
•
The default power supply is AC.
Note

Connections

Obtain a broadband or Ethernet connection from your service provider.

Ethernet Devices

Identify the Ethernet devices that you connect to the router: hub, servers, and workstations or PCs.
Ensure that each device has a network interface card (NIC) for connecting to the Ethernet ports.
If you plan to configure the software using Cisco IOS commands through the console port, provide an
ASCII terminal or a PC that is running terminal emulation software to connect to the console port.
Cisco 800M Series Integrated Services Router Hardware Installation Guide
2-2
Items Shipped with your Router, page 2-2
Connections, page 2-2
Ethernet Devices, page 2-2
PWR CABLE - Country specific Power Cable, Max 1
PWR-30W-AC - Power Adapter
Chapter 2 Installing the Router