Installing On A Table; Mounting On A Wall - Cisco 800M series Installation Manual

Installing on a Table

A four rubber feet is provided as part of the router hardware (shown in
table mount while ordering. Insert the rubber feet at the bottom of the router. Connect the chassis to a
reliable earth ground. Keep at least 200 mm of clear space on both left and right side for heat dissipation.
Figure 2-1

Mounting on a Wall

Two brackets and six counter-sunk screws are provided as part of the router hardware. These brackets
and screws can be used for both rack mount and wall mount and the brackets can be oriented in different
angles based on the need for wall mount and rack mount.
For wall mount, the supported configurations for the router are:
•
•
To mount the router on a wall, follow these steps:
Attach the two brackets to the chassis using the three screws provided for each bracket such that the
Step 1
brackets are facing the bottom of the router, as shown in
Orient the Cisco 800M Series router, facing the I/O side facing upwards as shown in
Step 2
the opposite direction such that the I/O side is facing downwards as shown in
Cisco 800M Series Integrated Services Router Hardware Installation Guide
2-4
Four Rubber Feet
I/O side facing upwards, as shown in
I/O side facing downwards, as shown in
Figure 2-2
Figure 2-3
Chapter 2 Installing the Router
Figure 2-1) if you have opted for
Figure 2-2, or in
Figure 2-3.