Connecting A Pc, Server, Or Workstation - Cisco 800M series Installation Manual

Connecting a PC, Server, or Workstation

To connect a PC (or other Ethernet devices) to an Ethernet switch port, follow these steps:
Connect one end of the Ethernet cable to an Ethernet switch port on the router, as shown in
Step 1
The connections remain the same for a 4 port module.
Note
Figure 3-1
1
2
Connect the other end of the cable to the RJ-45 port on the network interface card (NIC) that is installed
Step 2
in the PC, server, or workstation.
(Optional) Connect additional servers, PCs, or workstations to the other Ethernet switch ports.
Step 3
Cisco 800M Series Integrated Services Router Hardware Installation Guide
3-2
Connecting a Server, PC, or Workstation
1
Ethernet cable
Ethernet switch port on the router
2
3
3 RJ-45 port on the network interface card
Chapter 3 Connecting the Router
Figure 3-1.