Installing The Router; Equipment, Tools, And Connections; Items Shipped With Your Router - Cisco 807 Hardware Installation Manual

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the IR807 and contains the following
sections:

Equipment, Tools, and Connections, page 27

Installing the Router, page 28
Before installing the IR807, make sure you have read and understood all of the information included in the documentation
included with the product. An on-line version is also available here:
http://www.cisco.com/c/dam/en/us/td/docs/routers/access/800/807/GettingStarted/78-101247.pdf
CAUTION: Do not install the router or power supplies next to a heat source of any kind, including heating vents.
WARNING: Read the installation instructions before connecting the system to the power source. Statement 1004
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
WARNING: No user-serviceable parts inside. Do not open. Statement 1073
WARNING: Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
WARNING: Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such
circuits, because they may cause serious injury or death. For proper installation and grounding of the antenna, please
refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian
Electrical Code, Section 54). Statement 1052
WARNING: This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory
compliance and legal requirements may apply for direct connection to the Cable Distribution System. This product may
connect to the Cable Distribution System ONLY through a device that is approved for direct connection. Statement 1078

Equipment, Tools, and Connections

This section describes the equipment, tools, and connections necessary for installing your Cisco 807 ISR. It contains the
following topics:

Items Shipped with your Router, page 27

Additional Items, page 28

Ethernet Devices, page 28

Items Shipped with your Router

Unpack the box and verify that all items listed on the invoice were shipped with the Cisco 807 ISR.
The following items are shipped with your router:
Cisco Systems, Inc. www.cisco.com
27