Installing The Router; Equipment, Tools, And Connections - Cisco IR829 Hardware Installation Manual

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the Cisco IR829 and contains the
following sections:


CAUTION: Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not stack
routers on a desktop. Excessive weight on top of the router could damage the chassis.
CAUTION: Do not install the router or power supplies next to a heat source of any kind, including heating vents.
WARNING:
WARNING:
Statement 1030
WARNING:
WARNING:
1040
WARNING:
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such
circuits, because they may cause serious injury or death. For proper installation and grounding of the antenna, please refer
to national and local codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian
Electrical Code, Section 54). Statement 1052
WARNING:
regulatory compliance and legal requirements may apply for direct connection to the Cable Distribution System. This
product may connect to the Cable Distribution System ONLY through a device that is approved for direct connection.
Statement 1078

Equipment, Tools, and Connections

This section describes the equipment, tools, and connections necessary for installing your Cisco IR829. It contains the
following topics:



Equipment, Tools, and Connections, page 39
Installing the Router, page 40
Read the installation instructions before connecting the system to the power source. Statement 1004
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
No user-serviceable parts inside. Do not open. Statement 1073
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can
This product is not intended to be directly connected to the Cable Distribution System. Additional
Items Shipped with your Router, page 40
Additional Items, page 40
Ethernet Devices, page 40
Cisco IR829 Industrial Integrated Services Router Hardware Installation Guide
39