Fail-Safe - Channel 2 (Throttle); Beginner Mode And Feature Lock; Led Torch - IKONNIK ET4DS Owner's Manual & Technical Information

Fail-Safe - Channel 2 (Throttle)

WARNING: AS A SAFETY PRECAUTION PERFORM THE FAIL-SAFE SETTING WITH THE
MOTOR UNPLUGGED FROM THE ESC AND WITH ALL PARTS OF YOUR VEHICLE OFF
THE GROUND
It is recommended and common to set the throttle fail-safe as full brake, i.e.
the throttle trigger is pressed completely forward. This ensures that if the
transmitter's signal is lost the servos or ESC will default to full brake, causing
the vehicle to stop.
1. Turn the transmitter ON and move the throttle trigger to the desired (fully
forward) position.
2. Press the Fail-Safe button (4) for 5 seconds until a single beep is heard.
This will confirm that the throttle fail-safe has been set.
3. To test the Fail-Safe settings, turn the transmitter OFF while the receiver
is ON. The servo / ESC will default to its programmed positions and the
motor should not spin (assuming you have set the Fail-Safe to full brake).
Note: Each model memory has its own unique fail-safe setting so they each need
to be set independently.

Beginner Mode and Feature Lock

Your IKONNIK transmitter is equipped with two proprietary features to
improve and safeguard your experience with radio controlled products.
Uniquely implemented by IKONNIK are both a Beginner Mode and Feature
Lock. To avoid accidental changing of radio settings by inexperienced or
younger users, you can set the mode switch to the middle position which
will lock out all functions except the steering trim. Moving the switch all the
way to the right (when looking from the top of the transmitter, will activate
the Beginner Mode which is optimized to help users get used to the controls
of their vehicles. When activated, this beginner mode reduces the throttle
output of the transmitter to 50%, thus reducing the overall speed of the
vehicle, while leaving all other functions fully operational.
Note: The beginner mode and feature lock are not model specific. The model can
still be changed as described below.

LED Torch

Your ET4Ds is equipped with a high intensity LED torch light which can be
massively useful when working on your vehicle in low light conditions. Use
button (14) to toggle the torch ON / OFF.
Beginner Mode
Standard Mode
13