Table of Contents
Advertisement
Memory Reset
The transmitter has two memory reset features. The first is an individual
model reset which as it might sound, resets most parameters to their factory
default settings without affecting other models in memory. The second is
a full factory reset which restores all parameters to their factory default
settings and removes all paired receivers from memory. Perform the steps
below for each option.
Model Reset
1. Hold down the Steering D/R (+) and (-) buttons at the same time and
power ON the Transmitter.
2. Continue holding for 5 seconds until you hear a beep sound,
then release the buttons.
Factory Reset
1. Hold down the Steering D/R (+) and (-) buttons at the same time and
power ON the Transmitter.
2. Continue holding for 10 seconds until you hear 2 beep sounds, then
release the buttons.
Note: The transmitter will emit the model reset signal at 5 seconds, keep holding
until the factory reset signal is emitted.
Power Alarm and Automatic Shut-Down
Idle Alarm
When the steering wheel, throttle trigger, or other controls are not operated
for approximately 9 minutes while the transmitter is ON, a slow beeping alarm
will be emitted. After 1 minute of this alarm, the transmitter will emit one
long beep, then enter into "Sleep Mode" to prevent over-discharge of your
batteries. To silence the alarm, operate any part of the transmitter. To recover
from Sleep Mode, turn the transmitter OFF then back ON.
Low Battery Voltage Alarm
If the transmitter battery voltage drops to approximately 4.5V or less, a slow
beeping alarm sounds and the power LED light will blink. Safely discontinue
use and change or charge the batteries before using again.
Battery Replacement and Options
AA Alkaline
AA size alkaline batteries are the standard configuration and recommended
for ease of use when getting started. Upgrading to a rechargeable battery
pack can be done at any time
18
Dual-Rate
buttons
Hide quick links:
Advertisement
Table of Contents
