Table of Contents
Advertisement
• AUX (Channel 4): Controlled by button (ON/OFF) for optional use. This
port is most commonly used for LED light kits. Use this port to connect
an external battery for use with gas powered vehicles.
CAUTION: NEVER CONNECT A BATTERY WITH VOLTAGE HIGHER THAN 6.0V TO THE
RECEIVER, DOING SO COULD DAMAGE THE ELECTRONICS.
Pairing the Transmitter and Receiver
The process of allowing communication to occur between a 2.4GHz
transmitter and receiver is called 'pairing' (sometimes referred to as
'matching' or 'binding'). The radio system comes pre-configured and paired
from the factory. In the event that your system loses pairing, or one of the
components has been replaced, you will need to pair the transmitter and
receiver. Follow the steps below for pairing your radio system. For best results
always ensure that both transmitter and receiver batteries are fully charged
or new when performing this process.
WARNING: AS A SAFETY PRECAUTION, PERFORM THE PAIRING PROCESS WITH ALL
PARTS OF YOUR VEHICLE OFF THE GROUND AND THE WHEELS FREE TO SPIN.
1. With the transmitter in close proximity but not closer than 300mm
(12inches) to the receiver, turn ON the receiver (the red LED will flash
slowly) and press the PAIR button (the red LED will flash quickly indicating
that the receiver is not paired to a transmitter that is on).
2. Ensure you are using the correct or desired model for your vehicle, re-
check then continue if necessary.
3. Press the REV button (7) on the transmitter and turn the power ON.
Release the REV button to put the transmitter into pairing mode.
4. Once the transmitter and receiver are paired, the receiver's LED will turn
solid red. If the receiver's LED does not turn solid red, switch both the
transmitter and receiver OFF and repeat steps 1 – 3.
5. Once pairing is complete, ensure normal operation of throttle and
steering before placing the vehicle back on the ground.
6. If you experience anything other than normal operation, repeat the
process or consult the Troubleshooting Guide in the full online manual.
Basic Operation
The ET4Ds allows you to adjust a variety of settings that can improve
the performance and handling of your vehicle. The most basic of these
adjustments can be made in two ways, using either the external switches and
buttons – 7 8 9 11 12 14 – or the LCD / Roller Button interface – 15
16 17 Using the external switches and buttons adjustments can be made
as described on the next page.
10
REV/Pair
button
Hide quick links:
Advertisement
Table of Contents
