Hanging The Fan; Making The Electrical Connections - NOMA 052-1196-4 Instruction Manual

Warning: Turn off the power.
!
Follow the steps below to hang your fan properly.
1. Unscrew three mounting bracket screws from the mounting bracket
and plate.
2. Carefully lift the fan motor assembly (without the blades) and
insert the plate of the fan motor assembly into the slot in
the mounting bracket as shown in Fig. 4.
3. Screw the hook screw to the building structure. Hook the safety cable
to the hook screw as shown in Fig. 4.
You are now ready to make the electrical connections.

Making the Electrical Connections

Warning: To avoid possible electric shock, be sure
!
electricity is turned off at the main fuse box before
wiring.
If you feel you do not have enough electrical wiring knowledge
or experience, have your fan installed by a licensed electrician.
Follow the steps below to connect the fan to your household
wiring. Use the wire nuts supplied with your fan. Secure the wire
nuts with electrical tape. Make sure there are no loose strands or
connections.
1. Connect the ground conductor of the 120 V supply (this may
be a bare wire or a wire with green-coloured insulation) to the
green ground lead(s) of the fan (see Fig. 5).
2. Connect the fan motor white wire to the supply white (neutral)
wire using a wire nut (see Fig. 5).
3. Connect the fan motor black wire to the supply black (hot)
wire using a wire nut (see Fig. 5).
4. Connect the blue wire for the light kit to the black (hot) household
supply wire using a wire nut (see Fig. 5).
5. Turn wire nut connections upward, spreading them apart so
the green (ground) will be on one side of the outlet box and the
white, black and blue wires will be on the other side, and push
carefully up into the outlet box.
Warning: To reduce the risk of electric shock or fire, do not
!
use this fan with any solid-state fan-speed control device. It
will permanently damage the electronic circuitry.
Warning: Check to see that all connections are tight, includ-
!
ing ground, and that no bare wire is visible at the wire nuts,
except for the ground wire.
Warning: Electrical diagrams are for reference only.
!
Optional use of any light kit must be UL listed and marked
"suitable for use with this fan."

Hanging the Fan

5
Safety cable
Plate
Motor
Fig. 4
SUPPLY CIRCUIT
Fig. 5
Outlet box
Slot
Ground
conductor
Outlet box
Green
ground
lead
Ground from plate