Hanging The Fan - NOMA Mercer 54" Owner's Manual

Disassemble the Canopy Assembly
1. Remove the decorative canopy bottom cover from the canopy
by turning the cover counter clockwise. (Fig. 4)
2. Remove the mounting bracket from the canopy by removing
1 of the 2 screws from the bottom of the mounting bracket and
loosening the other one a half turn from the screw head. Next,
turn the canopy counter clockwise to remove the canopy cover
from the canopy. (Fig. 4)
Warning: Do not use the existing mounting bracket in the
!
outlet box; replace it with new mounting bracket.
REMEMBER to turn off the power. Follow the steps below to
hang your fan properly.
1. Remove the clevis pin, cotter pin and set screws from the top
of the motor assembly. (Fig. 5)
2. Route wires exiting from the top of the fan motor through the
coupling cover, canopy cover, canopy and then through the
ball/downrod. (Fig. 5)
NOTE: If a longer downrod (not included) is needed, take out
the screw located in the hanger ball, lower the hanger ball and
remove the pin, remove all 3 pieces from the downrod and
assemble them onto the new longer downrod before proceeding
to step 2.
3. Align the holes at the bottom of the downrod with the holes in
the coupling on top of the motor housing (Fig. 5). Carefully
insert the clevis pin through the holes in the collar and
downrod. Be careful not to jam the clevis pin against the
wiring inside the downrod. Insert the cotter pin through the
hole near the end of the clevis pin until it snaps into its locked
position, as noted in the circle inset in Fig. 5.
Warning: Failure to properly install cotter pin as noted in
!
step 5 could result in fan loosening and possibly falling.
4. Tighten two set screws at top of the fan motor collar firmly
and evenly. (Fig. 5)
5. Carefully lift the fan assembly up to the ceiling mounting
bracket and seat the hanger ball in the mounting bracket
socket. Make sure the tab on the mounting bracket socket is
properly seated in the groove in the hanger ball (Fig. 6).
This will help to balance the ceiling fan.
6. Secure the safety cable to the building structure using a wood
screw (not included).
Warning: The tab in the ring must rest in the groove of the
!
hanger ball as fig. 6. Failure to properly seat the tab in the
groove could cause damage to wiring.

Hanging the Fan

5
Fig. 4
Motor wires
Canopy
Ball/downrod
assembly
Canopy bottom
cover
Cotter pin
Set screws
Fig. 5
Safety cable
Groove
Fig. 6
Ceiling
mounting
bracket
Canopy
Canopy bottom
cover
Pin in locked
positioon
Coupling cover
Motor collar
Clevis pin
Tab