Juniper ACX5048 Quick Start Manual page 11

Copyright © 2015, Juniper Networks, Inc.
Permit only trained and qualified personnel to install or replace router components.
Perform only the procedures described in this quick start and the ACX5000 router
documentation. Other services must be performed only by authorized service personnel.
Before installing the router, read the planning instructions in the ACX5000 router
documentation to make sure that the site meets power, environmental, and clearance
requirements for the router.
Before connecting the router to a power source, read the installation instructions in
the ACX5000 router documentation.
The ACX5048 router weighs approximately 21.8 lb (9.8 kg). Manually installing the
ACX5048 router in a rack or cabinet at a height above 60 in. (152.4 cm) requires two
people to lift the router and install mounting screws. To prevent injury, keep your back
straight and lift with your legs, not your back.
If the rack or cabinet has stabilizing devices, install them in the rack before mounting
or servicing the router in the rack or cabinet.
Before installing or after removing an electrical component, always place it
component-side up on a flat antistatic mat or in an antistatic bag.
Do not work on the router or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including
rings, necklaces, and watches. Metal objects heat up when connected to power and
ground and can cause serious burns or become welded to the terminals.
CAUTION: Do not place a copper transceiver in an access port directly above
or below another copper transceiver. Doing so can damage the access ports.
WARNING: The attached power cable is only for this product. Do not use this
cable for another product.
Power Cable Warning (Japanese):
Safety Warnings
11