Table of Contents
Advertisement
2: Installation and Startup
This chapter shows how to connect, install and start the Sierra Wireless MP70. It also
describes the front panel LEDs, and I/O functionality.
Note: Sierra Wireless recommends that a professional vehicle electronics installer perform the
installation. An experienced installer typically completes a standard installation in approximately
half an hour.
Tools and Materials Required
•
•
•
•
•
•
•
Caution:
you are installing it in these types of environments, use cables designed and specified for use
in these types of environment to avoid cable failure.
Installation Overview
The steps for a typical installation are:
1. Insert the SIM
2. Mount and ground the MP70
3. Connect the
4. Connect the data
5. Connect the
6. Check the router
Rev 4 Nov.16
A SIM card (provided by your mobile network operator)
#1 Phillips screwdriver
Laptop computer with Ethernet cable
AC or DC power cable (available from Sierra Wireless or use your own custom
cable)
Cellular antenna
Recommended—diversity antenna
Optional:
· GNSS antenna
1
· Wi-Fi antennas
· 9-pin connection cable for the RS-232 port
· 8-pin auxiliary I/O connector cable
The router has a hardened case for use in industrial environments and vehicles. If
card(s)—page
antennas—page
cables—page
power—page
operation—page
1. Applies only to the MP70 Wi-Fi model
9
10.
chassis—page
11.
12.
14.
14.
26.
2
4119008
Hide quick links:
Advertisement
Table of Contents
