Sierra Wireless AirLink MP70 Quick Start Manual

®
AirLink MP70 Quick Start Guide
This guide provides instructions for quickly getting your Sierra Wireless
For more information refer to the:
• AirLink MP70 Hardware User Guide
®
• ALEOS Software Confi guration User Guide
Both are available for download from the Sierra Wireless web site (source.sierrawireless.com).
NOTE: Remote ACEmanager access is disabled by default for security. If required, enable it remotely using ALMS or locally using
ACEmanager (Services > ACEmanager) and change the default password (Admin > Change Password).
STEP 1 Install the SIM Cards
1. Use a #1 Phillips screwdriver to remove the SIM card cover.
2. Slide the SIM cards into the SIM card slots until they click into place.
By default, the SIM card in slot 1 (the upper slot) is the Primary SIM card. When the
MP70 is powered on or reboots, it automatically connects to the network associated
with the Primary SIM card.
3. Re-attach the cover.
STEP 2 Connect and Turn On the Router
NOTE: If you want to confi gure all your routers at the same time using AirLink Management Service, follow the instructions on page 2 to
register your routers before applying power.
5. Connect the Wi-Fi
antennas,
if applicable.*
4. Connect a
Windows ®
computer to the
router with an Ethernet cable. If applicable, connect devices to the
RS-232 port and / or the USB port.
* Available only on the Wi-Fi enabled MP70.
© 2016 Sierra Wireless All Rights Reserved PN 2400506 Rev. 1
® ®
AirLink MP70 router confi gured and connected.
Green (GPIO) Optional
Black (GND)
** The Ignition Sense must be connected to vehicle ignition.
Page 1
Slot 1
Slot 2
1. Connect the Cellular
and GNSS antennas.
2. Recommended: Connect the
diversity antenna.
3. Connect 9-36 VDC. To operate
the router between 7 – 36 V,
after startup, launch ACEmanager,
go to Services > Power
Management, and adjust the low
voltage standby settings.
White (Ignition Sense)**
Red (Power)