Sierra Wireless AirLink MP70 Hardware User's Manual page 36

AirLink MP70 Hardware User Guide
Table 3-1: Specifications (Continued)
Power Adapter Pins
Reset
LEDs
See LED Behavior on page 27.
Mechanical Specifications
For mechanical drawings, dimensions, and
weight, see Mechanical Specifications
page 43.
Screw Torque Settings
Operating Voltage
Rev 4 Nov.16
4-Pin connector:
Power
•
Ground
•
Configurable digital I/O and analog voltage input sensing
•
Configurable ignition sense
•
Manual reset button or using ACEmanager
6 LEDs:
Power
•
Network
•
Signal
•
Activity
•
GNSS
•
Wi-Fi
•
Housing—The MP70 is made of ruggedized powder-coated
•
aluminum.
on RoHS2—The MP70 complies with the Restriction of Hazardous
•
Substances Directive 2011/65/EU (RoHS2). This directive
restricts the use of hazardous materials in the manufacture of
various types of electronic and electrical equipment.
Mount screws
•
1.1 N-m (10 in-lb)
Antennas
•
Finger tight (5–7in-lb.) is sufficient and the max torque should
not go beyond 1.1 N-m (10 in-lb).
Input voltage: 7–36V
By default, the router is configured to enter Standby mode at 9 V. If
you want to operate the router at less than 9 volts, power it on using
at least 9 V, launch ACEmanager, go to Services > Power
Management and adjust the Standby mode settings.
The maximum ripple voltage to guarantee analog input accuracy
must be 100 mVpp.
36 4119008