Installation Concerns; Contents Of The Box; Seat Assembly; Side Impact Protection (Sip) Pods - Nuna Aace Instructions Manual

Installation Concerns

!
DO NOT install this booster on vehicle seats with
Lap Belts only. (1)
!
This booster is suitable for vehicle seats with a
3-point Retractor Safety Belt. (2) If your vehicle has
ISOFIX Anchor Points, we strongly recommend
that you connect the ISOFIX connector to the
ISOFIX Anchor Points together. (3)
!
DO NOT install this booster on vehicle seats that
face sideways or rearward with respect to the
moving direction of the vehicle.
!
Please refer to your vehicle owner's manual for
recommended or suggested installation positions.
(4)-1
!
This booster must be installed in the rear vehicle
seat. (4)-2
!
DO NOT install this on movable vehicle seats during
installation.

Contents of the Box

Booster
Tools Needed: None
16

Seat Assembly

1. With the seat lying flat, attach the seat back to the booster seat
bottom by hooking the seat back hooks over the seat bottom as
(5)
shown.
2. Now rotate the seat back up until it clicks into position and the
seat is fully upright as shown.
Side Impact Protection
(SIP) Pods
1. To open the SIP Pods pull out on the side tab
(8)-1
2. To close push button and push in
!
SIP Pods should be deployed whenever the booster is
installed in a vehicle. You may push in the inboard SIP pod if it
interferes with an inboard passenger.
Height Adjustment
for Head Support
1. The Head Support height can be adjusted for best fit to your
child and proper placement of the Vehicle Shoulder Belt.
2. To adjust, squeeze the Head Support Adjustment Lever, then pull
(9) (10)
up or push down the Head Support until it locks into
one of the 11 positions as shown.
!
Before adjusting the head support height have your child lean
forward slightly.
!
As the Head Support is adjusted up, the sides of the seat
automatically move outward to provide more shoulder room.
(6)
(7)
.
(8)-2
.
17