Fill The Water Tank - Sharp KC-JG20A Operation Manual

Fill the Water Tank

Fill tap water in the Water Tank to operate the unit in the Clean Air & Humidify mode.
Fill water
Click
• Use tap water only. (Otherwise, breed of bacteria may occur)
• Do not fill hot water (≥ 40°C), aroma oil, chemicals, dirty water, detergent or aromatic
Caution
substances into the Water Tank. (Otherwise, cracks and/or water leakage could result)
Press down the
Handle of Water Tank,
and then pull the
Water Tank out
Handle of
water tank
Water tank
Unscrew the
Tank cap Water Tank Cap
and fill tap water
in the Water Tank
Water tank
Tighten the
Water Tank Cap
Install the Water
Tank
• Be careful, do not let water spill over.
• Before filling water, drain the remaining
water in the Water Tank and then rinse
it by shaking with a small amount of
fresh tap water.
The Water
Tank is
self-standing.
• Tighten the Cap firmly to make
sure no water leaks out.
• Be sure to wipe off water droplet
on the Water Tank.
• Take care not to get fingers caught
between the main unit and Water
Tank.
• Firmly hold the main unit for
mounting the Water Tank.
E-9