Configuration Management Menu; Start Operation - Funkwerk bintec R230aw User Manual

Flash
RAM
Operations
Windows
Unix
Configuration Management
1

Configuration Management Menu

The C M
ONFIGURATION ANAGEMENT
R232bw Setup Tool
[CONFIG]: Configuration Management
Operation
Name in Flash
Type of last operation
State of last operation

START OPERATION

The gateway saves its configuration in configuration files in the flash EEPROM
(Electronically Erasable Programmable Read Only Memory). The data also re-
mains stored in the flash when the gateway is switched off.
The current configuration and all changes you set on the gateway during oper-
ation are stored in the working memory (RAM). The contents of the RAM are
lost if the gateway is switched off. So if you modify your configuration and want
to keep these changes for the next time you start your gateway, you must save
the modified configuration in the flash memory before switching off: E
AS BOOT CONFIGURATION AND EXIT
as a boot configuration file under the name "boot". The "boot" configuration file
is used as default when starting the gateway.
The files in the flash memory can be copied, moved, erased and newly created.
It is also possible to transfer configuration files between the gateway and a host
➤➤
via TFTP.
In Windows, you can use the TFTP server of
(see BRICKware for Windows).
A TFTP server is part of the system under Unix.
Configuration Management Menu
submenu is described below.
Funkwerk Enterprise Communications GmbH
save (MEMORY -> FLASH)
boot
EXIT
. This configuration is then saved in the flash
➤➤
DIME Tools for this transfer
bintec User's Guide
1
MyGateway
➜
S
XIT AVE
3