Table of Contents
Advertisement
7 Self-Diagnostic and Special Mode Setting
7.1.
Special Mode Table 1
Self-Diagnostic Function provides information for error to service personnel by Self-Diagnosis Display when any error has occurred.
U**, H** and F** are stored in my memory and held.
• You can check latest error code by transmitting [0] [1] of Remote Control in Service Mode.
Automatic Display on FL will be cancelled when the power is turned off or AC input is turned off during self-diagnosis display is
ON.
Mode name
Initialize Mode
Rating password
Service Mode
BD-ROM history cleaning < Persistent Storage> of BD-ROM standard is
Forced disc eject
Forced power-off
Aging
Item
Description
*A
ll the main unit's parameters are initialized.
1) Unit power-up
2) FL shows "Hello" then "goodbye"
3) Unit power-down
4) Unplug & plug AC Cord
The audiovisual level setting password is ini-
tialized to
Level
8.
Setting every kind of modes for servicing.
*Details are described in
7.3.1. Service Mode
at a
glance.
cleaned.
Screen display: [The player's history data has
been cleared] is displayed for five seconds.
Removing a disc that cannot be ejected.
The tray will open and unit will shift to P-off
mode.
While Demonstration Lock is being set, this
Forced disc eject function is not accepted.
When the power button is not effective while
power is ON, turn off the power forcibly.
Perform sequence of modes as * Aging
Description shown below continually.
FL display
-----------
INIT
INIT
SERV
******
******
Same display as before
execution.
The
display
before
execution leaves.
******
Display in P-off mode.
Display following the mode. When the power is ON, press
27
Key operation
Front Key
Press & hold [VOL+], [OPEN/
CLOSE] follow by [POWER]
button in sequence during
power off.
Press [SKIP REV] on remote
control, follow by [PLAY] on main
unit simultaneously for five
seconds when power-on.
Press & hold [VOL+], [OPEN/
CLOSE] & [PLAY] on main
unit for 3S or more during
power off.
When power on press [STOP] on
main unit & [POWER] on remote
control.
When power is off, press [SKIP
FWD] on remote control & [OPEN/
CLOSE] key on main unit
simultaneously for 5 seconds
or more.
P
ress [POWER] over than 10
seconds.
[SKIP FW], [PLAY] & [OPEN/
CLOSE] simultaneously for over
seconds and less than 10 seconds.
NOTE1:
If Unit has not turned into Aging
mode by operations shown above,
execute TEST MODE once and re-
execute operation shown above.
(*All the main unit s parameters
include tuner are initialized by TEST
mode.)
NOTE2:
If the unit has hung-up because of
pressing keys for over 10 seconds,
once turn off the power, and re-exe-
cute this command.
*When releasing Aging mode, press
[POWER] key over 10 seconds.
5
Advertisement
Table of Contents
