Table of Contents
Advertisement
SA-PT660P / SA-PT660PC
8 Self-Diagnosis and Special Mode Setting
8.1.
Service Mode Summary Table
8.1.1.
Service Mode Table (For DVD)
The service modes can be activated by pressing various button combination on the main unit and remote control unit.
Below is the summary for the various modes for checking:
Main unit buttons
Remote control unit buttons
[STOP]
Note:
An error code will be canceled if a power supply is turned OFF.
*1: CPPM is the copy guard function beforehand written in the disk for protection of copyrights.
*2: CEC is the consumer electronic control used for high-level user control of HDMI-connected devices.
*3: HDCP is the specification developed to control digital audio & video contents transmission for DVI or HDMI connections.
8.1.2.
Service Mode Summary Table (For CR14)
Main buttons
Remote control unit buttons
[STOP] +
[
/FF/
]
[1]
(In self-diagnostic
mode)
[2]
(In self-diagnostic
mode)
In Self Diagnostic
Mode
8.2.
Service Mode Table (For DVD)
By pressing various button combinations on the main unit and remote control unit, you can activate the various service modes for
checking.
Special Note:
• • • • Due to the limitations of the no. characters that can be shown on the FL Display, the "FL Display" button on the remote
control unit can be used to show the two display pages. (Display 1 / Display 2).
[0]
Error code check.
[5]
Jitter checking.
[PAUSE]
Initial setting of laser drive current.
[FUNCTIONS]
DVD laser drive current check.
[3]
CD laser drive current check.
[6]
Region display and mode.
[SOUND]
CPPM/CRM keys check.
[7]
Micro-processor firmware version check.
[
]
Initialization of the player (factory setting is restored).
Used after replacement of Micro-processor (DV5 LSI) IC,
FLASH ROM IC (IC8651), EEPROM IC (IC8611) and DVD
Module P.C.B.
[OK]
DVD Module P.C.B. reset.
[8]
DVD Module P.C.B. firmware version check.
[
]
Timer 1 check.
[
]
Timer 1 reset.
[
]
Timer 2 check.
[
]
Timer 2 reset.
-
Entering into self-diagnostic mode.
-
Servicing the mechanism unit.
-
Servicing the traverse unit.
[1]
Reliability 1 (Load)
[2]
Reliability 2 (Cycle)
[3]
Reliability 3 (Combi)
Application
Application
24
Note
(Refer to the section
"8.2.1. Service Mode
Table 1" for more
information.)
(Refer to the section
"8.2.2. Service Mode
Table 2" for more
information.)
(Refer to the section
"8.2.3. Service Mode
Table 3" for more
information.)
(Refer to the section
"8.2.4. Service Mode
Table 4" for more
information.)
Note
(Refer to the section
"8.3.1. Service Mode
Table 1" for more
information.)
(Refer
to
the
section
"8.3.2.
Service
Mode
Table
2"
for
more
information.)
Advertisement
Table of Contents
Troubleshooting
