Vacon 100 Installation Manual page 56

vacon • 54
Place the grommet with the cable so that the frame end plate fits in the groove
on the grommet, see Figure 43.
To meet the requirements of the enclosure class IP54, the connection between
8
the grommet and the cable must be tight. Therefore, lead the first bit of the cable
out of the grommet straight before letting it bend. If this is not possible, the tight-
ness of the connection must be ensured with insulation tape or a cable tie. As an
example,see Figure 29.
If you use thick cables insert the cable insulators in between the terminals in
9
order to avoid contact between the cables.
5
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Figure 43. Placing the grommet
Figure 44. Inserting the cable insulators
Power cabling
9040.emf
9032.emf