Pronto MAGICARD 3649 - 0001 Maintenance Manual page 86

This error is raised while trying to lower the PrintHead if the Cam Sensor does not unblock within 5
seconds. This function is called by the "HEAD" quick command, the cleaning routine and the soak
17:00 test routine.
17:00
This error is raised while lowering the PrintHead and analysing the image data if the Cam Sensor does
not unblock within 3 seconds. (Note that by this point the image data has been completely analysed.
This function is used during the printing routine before starting to print each colour panel).
17:01
This error is raised after carrying out magnetic verification if the data read back from the Card on the
final attempt does not match the data that was written. This error cannot occur if either verification
is switched off, or some other error (such as Lid open or Card jam) occurs during
19:00
19:00
encoding/verification.
This error is raised while processing an "MSV" command if the data read back from the Card does not
match the data written within 4 attempts.
19:01
This error is raised while determining the format of the downloaded print job if colour printing has
been requested for the front of the Card but the Printer does not support colour printing.
20:00
20:00
This error is raised while determining the format of the downloaded print job if colour printing has
been requested for the back of the Card but the Printer does not support colour printing.
20:01
This error is raised if the cleaning prompt is enabled and the "clean required" ag has been set. This
ag gets set when the number of Cards printed since the last clean exceeds the user configurable
21:00 threshold (by default - 700). (Note that this check only gets performed at Printer Boot-up).
21:00
Test, initiated using an "SNS" command, if the Printer found that the Cam Sensor never toggled.
22:00
22:00
This error is raised after completing a Sensor test, initiated using an "SNS" command, if the Cam
Sensor toggled but the flip Sensor never saw the light.
22:01
This error is raised after completing a Sensor test, initiated using an "SNS" command, if the Cam
Sensor toggled but the flip Sensor never got obscured.
22:02
This error is raised after completing a Sensor test, initiated using an "SNS" command, if the Cam and
flip Sensors both toggled.
22:03
Ultra Electronics Ltd
19 - MAG VERIFY FAIL
Press Retry or Cancel to continue.
20 - MODE UNSUPPORTED
Cannot print requested image with this Printer model.
21 - CLEAN REQUIRED
Please clean Rollers to avoid deterioration.
22 - TEST RESULTS
This error is raised after executing a Sensor
Pronto Maintenance Manual
- 86 -