Pronto MAGICARD 3649 - 0001 Maintenance Manual page 80

This error is raised while trying to rewind the Card to the standby position (i.e. Over the mid Sensor)
if the mid Sensor stays clear for more than 2 seconds. This function is called to reposition the Card
after performing mag verification in the forwards direction.
04:06
Not applicable to the PRONTO.
04:07
This error is raised while trying to return the Card to the print Engine after rotating it if the front
Sensor is not obscured within 5 seconds.
04:08
This error is raised while trying to return the Card to the print Engine after rotating it if we fail to
clear the front Sensor within 5 seconds. Note that the Sensor has already been obscured by the Card
at this stage.
04:09
This error is raised while trying to feed a Card into the flip mechanism for rotation if the front Sensor
is not cleared within 5 seconds. By this point, the Card has already moved forward to block the
Sensor.
04:10
This error is raised while trying to eject the Card from the Printer if the front Sensor remains blocked
for more than 3 seconds. At this stage, the Card has already been moved towards the flip
mechanism and has blocked the front Sensor.
04:11
This error is raised while trying to move the Card from the smart encoding position to the standby
position if the Card present Sensor does not register the Card leaving within 3 seconds.
05:00
05:00
This error is raised while trying to place the Card into the smart encoding position if the Card present
Sensor does not register the arrival of the Card within 2 seconds.
05:01
This error is raised while trying to roll a Card backwards to the smart encoding position if it takes
more than 2 seconds for the encoder contact switch to be made.
05:02
This error is raised while measuring the positions of the resin calibration marks on the image position
setup Card if we fail to see the trailing edge of a dark bar within 10 seconds. Note that we have
06:00 already detected the edge of the Card and a light-to-dark bar transition by this point.
06:00
This error is raised in Pronto print Engines while trying to rewind a Card to the "ready-to-mag-
encode" position if the rear Sensor is not obscured within 4 seconds.
06:01
This error is raised while positioning the Card at the front Sensor during image position calibration if
we fail to see the Card arrive at the Sensor within 5 seconds.
06:02
This error is raised while measuring the positions of the resin calibration marks during image position
calibration if we fail to see the leading edge of the Card arrive at the front Sensor within 10 seconds.
Note that the Card is moving backwards at this point, so the leading edge is actually the back edge.
06:03
Ultra Electronics Ltd
05 - ENCODER JAM
Please clear Printer mechanism.
06 - CARD JAM 2
Please clear Printer mechanism.
Pronto Maintenance Manual
- 80 -