Replacing The Print Head (Cont) - Pronto MAGICARD 3649 - 0001 Maintenance Manual

SECTION 10.3

REPLACING THE PRINT HEAD (CONT).

CAUTION Care must be taken when disconnecting and connecting the Print Head Assembly. The electrical
connector (located on the Print Head) is mounted on a soft flexible electronic circuit board. Damage
can occur if excessive force is used at any time.
Ultra Electronics Ltd
Disconnect the
connector
Re-fit the new
Print Head
1
2
Pronto Maintenance Manual
- 34 -
Push backwards
then tilt upward
2
1
Refit the
connector