Section 19 Pronto Error Codes - Pronto MAGICARD 3649 - 0001 Maintenance Manual

SECTION 19 PRONTO ERROR CODES
This error is raised if the Lid is opened while trying to feed a Card from the Hopper, unless the Printer
is in feed-soak mode (in which case the Lid is ignored, and this error cannot occur).
01:00
01:00
This error is raised by the Printer User Interface Module if it detects that there is a pending print job
while the Lid is open.
01:01
This error is raised if the Lid is opened while printing a colour panel.
01:02
This error is raised if the Lid is opened while printing the resin black panel, or if the Lid is opened
while printing with continuous resin Film.
01:03
This error is raised if the Lid is opened while printing the overcoat panel.
01:04
This error is raised if the Lid is opened during the Dye LED calibration process.
01:05
This error is raised if the Lid is opened while winding the Film on to the start of the next panel. This
may be either during printing or initialisation.
01:06
This error is raised if the Lid is opened while aligning the start of a Dye panel with the edge of the
PrintHead. This may be either during printing or initialisation.
01:07
This error is raised if the Lid is open when we are vaLidating the print job parameters against the
Printer setup. This can happen if we send a print job to the Printer while the Lid is open.
01:08
This error is raised if the Lid is opened while we are trying to take up the slack in the Dye-Film. Note
that this function is called after resetting the Cams on initialisation or reinitialisation, and also after
printing each panel.
01:09
This error is raised by the Pronto user interface module if it detects that there is a pending print job
while the Lid is open.
01:10
This error is raised by Pronto models if the Lid was opened while the Printer was waiting for an
ejected Card to be removed from the Card slot.
01:11
Ultra Electronics Ltd
01 - LID OPEN
Please close Lid to continue.
Pronto Maintenance Manual
- 78 -