Pronto MAGICARD 3649 - 0001 Maintenance Manual page 85

This error is raised while waiting for the PrintHead temperature to fall before printing a Card if the
measured temperature is out of range.
14:00
14:00
This error is raised while waiting for the PrintHead temperature to fall before printing a Card if it takes
more than 2 minutes for the temperature to drop below 68 C.
14:01
This error is raised during the print cycle, while waiting for the main Stepper motor to reach the
appropriate position for the next printing pass, if the Printer detects that the motor has already
15:00 passed that position. This can sometimes occur when the image being printed is very dark, and/or
15:00
the PrintHead temperature is very low.
This error is raised while resetting the Cam to the "head up" position if the Printer does not see the
Cam Sensor block within 5 seconds.
16:00
16:00
This error is raised while trying to reset the Cam to the "head up" position if the Printer does not see
a light-to-dark Cam Sensor transition within 5 seconds. By this point the Cam Sensor is already
unblocked.
16:01
This error is raised while trying to lift the PrintHead if the Cam Sensor does not block within 5
seconds. Note that this function is only used by the "HEAD" quick command and the cleaning routine.
16:02
This error is raised while trying to lift the head at the end of printing a panel if the Cam Sensor does
not clear within 5 seconds. By this point the Sensor has already been blocked.
16:03
This error is raised while trying to place the Cam in the "head up" position if the Cam Sensor does not
block within 5 seconds. This function is only called during Printer Boot-up and print job cancellation.
16:04
This error is raised while trying to place the Cam in the "head up" position if the Cam Sensor does not
make a dark-to-light transition within 5 seconds. Note that the Sensor has already been blocked by
this point. This function is only called during Printer boot-up and print job cancellation.
16:05
This error is raised while trying to place the Cam in the "head up" position if the Cam Sensor does not
make a light-to-dark transition within 5 seconds. Note that by this point the Sensor has already
made a dark-to-light transition. This function is only called during Printer Boot-up and print job
16:06
cancellation.
This error is raised while lifting the PrintHead if the Cam Sensor does not block within 5 seconds.
16:07
This error is raised while trying to lift the PrintHead if the Cam Sensor does not block within 5
seconds. By this point the head has been lifted and the Cam Sensor has just unblocked, and the
Printer is pulsing the Cam motor backwards to prevent overrun.
16:08
Ultra Electronics Ltd
Please cancel print job and reduce Driver PrintHead power settings to try again.
16 - CANNOT LIFT HEAD
17 - CANNOT DROP HEAD
Pronto Maintenance Manual
15 - IMAGE TOO DARK
Check Printer mechanism.
Check Printer mechanism.
- 85 -