Getting Started; Hardware Installation Procedure - Wiznet WIZ105SR User Manual

2. Getting Started

This chapter describes the configuration steps of WIZ105SR. The following listed items which
are included in your WIZ105SR-EVB package will be required in configuration.
Power Adapter (included in the WIZ105SR-EVB package)

Serial and Ethernet Cable (included in the of WIZ105SR-EVB package)

A computer with Network Interface Card ( NIC) and/or one RS232 serial port

If you have prepared those things, the configuration of WIZ105SR can be getting started.
The board connection steps are introduced in section 2.1.

2.1. Hardware Installation Procedure

The following steps are required while to set up the configuration environment for
WIZ105SR and the connection diagram is shown in Figure 3.
Figure 2. WIZ105SR Configuration Environment Setting Diagram
STEP 1: Connect the WIZ105SR module to the test board by using the 12pin cable.
STEP 2: Connect the 5V DC power line to the power jack of the test board.
STEP 3: Use the RJ45 Ethernet cable in order to connect the module to an Ethernet
network.
STEP 4: Use the serial data cable to connect the test board to a serial device.
Hardwired Internet Connectivity Wizard (WIZnet, Inc.) 13