Siemens MICROMASTER 440 Operating Instructions Manual page 94

3 Functions
Reference voltage (entered in V)
P2001=1000
The reference voltage in Volt (output voltage) corresponds to a value of
100 %.
NOTE
This setting should only be changed if it is necessary to output the
voltage with another scaling.
Reference current (entered in A)
P2002 = ?
The reference current in Ampere (output current) corresponds to a
value of 100 %. Factory setting = 200 % of the rated motor current
(P0305).
NOTE
This setting should only be changed if it is necessary to output the
current with another scaling.
Reference torque (entered in Nm)
P2003 = ?
The reference torque in Nm corresponds to a value of 100 %. Factory
setting = 200 % of the rated motor torque, determined from the motor
data, for a constant motor torque.
NOTE
This setting should only be changed if it is necessary to output the
torque with another scaling.
Reference power (entered in kW / hp)
P2004 = ?
The reference power in kW / hp corresponds to a value of 100 %.
Factory setting = 200 % of the rated motor power at constant motor
torque.
NOTE
This setting should only be changed if it is necessary to output the
power with another scaling.
Transfer data from RAM to EEPROM
P0971 = 1
All of the parameter changes are transferred from the RAM memory
into the EEPROM memory which means that they are saved in a non-
volatile fashion in MICROMASTER (data is not lost when the power
fails).
NOTE
END
94
0 Disabled
1 Start data transfer, RAM->EEPROM
When using a BOP or AOP, MICROMASTER automatically carries-
out the RAM→EEPROM data save operation.
If the start-up tool STARTER or DriveMonitor is used to realize the
parameterization, then data is not automatically saved in the
EEPROM. Automatic data save RAM→EEPROM can be selected
using the appropriate selection button.
STARTER
RAM → EEPROM
DriveMonitor
Online-EEPROM
MICROMASTER 440
Issue 10/03
Operating Instructions
6SE6400-5AW00-0BP0