Table of Contents
Advertisement
STEP 3: Choose a layer 2 interface from the drop-down box and click Next.
The WAN Service Configuration screen will display as shown below.
NOTE:
The WAN services shown here are those supported by the layer 2
interface you selected in the previous step. If you wish to change your
selection click the Back button and select a different layer 2 interface.
STEP 4: For VLAN Mux Connections only, you must enter Priority & VLAN ID tags.
Select a TPID if VLAN tag Q-in-Q is used.
STEP 5: You will now follow the instructions specific to the WAN service type you
wish to establish. This list should help you locate the correct procedure:
(1) For
F2.1 PPP over ETHERNET
(2) For
F2.2 IP over ETHERNET
(3) For
F2.3
The subsections that follow continue the WAN service setup procedure.
(PPPoE), go to page 160.
(IPoE), go to page 166.
Bridging, go to page 171.
159
Hide quick links:
Advertisement
Table of Contents
