Led Indicators - Comtrend Corporation WR-6895 User Manual

2.2 LED Indicators

The front panel LED indicators are shown below and explained in the following table.
This information can be used to check the status of the device and its connections.
LED Color
GREEN
POWER
RED
GREEN
ETH WAN
YELLOW
GREEN
ETH 4 to 1
YELLOW
GREEN
WPS
YELLOW
WiFi
GREEN
2.4G
Mode
On The device is powered up.
Off The device is powered down.
POST (Power On Self Test) failure or other
malfunction. A malfunction is any error of internal
On
sequence or state that will prevent the device from
connecting to the DSLAM or passing customer data.
On WAN is connected at 1000 Mbps.
Off Ethernet WAN is not connected.
Blink In TX/RX over 1000 Mbps
On Ethernet is connected at 10/100 Mbps.
Off Ethernet WAN is not connected.
Blink In TX/RX over 10/100 Mbps.
On Ethernet is connected at 1000 Mbps.
Off Ethernet is not connected.
Blink In TX/RX over 1000 Mbps.
On Ethernet is connected at 10/100 Mbps.
Off Ethernet is not connected.
Blink In TX/RX over 10/100 Mbps.
On WPS(2.4G) WPS enabled and client connected to
WLAN.
Off WPS(2.4G) WPS disabled.
Blink WPS(2.4G) WPS connection in progress, 120
seconds or until client connected.
On WPS(5G WPS enabled and client connected to
WLAN.
Off WPS(5G) WPS disabled.
Blink WPS(5G) WPS connection in progress, 120 seconds
or until client connected.
On The wireless module is ready.
(i.e. installed and enabled).
The wireless module is not ready.
Off
(i.e. either not installed or disabled).
Blink Data transmitting or receiving over WLAN.
9
Function