Appendix F - Connection Setup
Creating a WAN connection is a two-stage process.
1 - Setup a Layer 2 Interface (Ethernet).
2 - Add a WAN connection to the Layer 2 Interface.
The following sections describe each stage in turn.
F1 ~ Layer 2 Interfaces
Every layer2 interface operates in Multi-Service Connection (VLAN MUX) mode,
which supports multiple connections over a single interface. After adding WAN
connections to an interface, you must also create an Interface Group to connect
LAN/WAN interfaces.
F1.1 Ethernet WAN Interface
The WR-6895 supports a single Ethernet WAN interface over the ETH WAN port.
Follow these procedures to configure an Ethernet interface.
STEP 1: Go to Basic Setup
from the drop-down menu.
This table is provided here for ease of reference.
WAN Setup Select ETHERNET Interface
156