Wps 2.4Ghz - Comtrend Corporation WR-6895 User Manual

6.11.3 WPS 2.4GHz

Wi-Fi Protected Setup (WPS) is an industry standard that simplifies wireless security
setup for certified network devices. Every WPS certified device has both a PIN
number and a push button, located on the device or accessed through device
software. The WR-6895 has a WPS button on the device.
Devices with the WPS logo (shown here)
support WPS. If the WPS logo is not present
on your device it still may support WPS, in
this case, check the device documentation
for the phrase "Wi-Fi Protected Setup".
NOTE: WPS is only available in Open, WPA-PSK, WPA2-PSK and Mixed
WPA2/WPA-PSK network authentication modes.
modes do not use WPS so they must be configured manually.
To configure security settings with WPS, follow the procedures below.
I. Setup
Step 1: Enable WPS by selecting Enabled from the drop down list box shown.
Step 2: Set the WPS AP Mode. Configured is used when the WR-6895 will assign
security settings to clients. Unconfigured is used when an external
client assigns security settings to the WR-6895.
NOTES: Your client may or may not have the ability to provide security settings to
the WR-6895. If it does not, then you must set the WPS AP mode to
Configured. Consult the device documentation to check its capabilities.
IIa. PUSH-BUTTON CONFIGURATION
The WPS push-button configuration provides a semi-automated configuration
method. The WPS button on the front panel of the router can be used for this
purpose.
The WPS push-button configuration is described in the procedure below.
Other authentication
104