Table of Contents
Advertisement
To enable Ethernet Service OAM (802.1ag/Y1731), click Enabled to display the full
configuration list.
WAN Interface
Select from the list of WAN Interfaces to send OAM packets
MD Level
Maintenance Domain Level
MD Name
Maintenance Domain name
MA ID
Maintenance Association Identifier
Local MEP ID
Local Maintenance association End Point Identifier
Local MEP VLAN ID
VLAN IP used for Local Maintenance End point
Click CCM Transmission to enable CPE sending Continuity Check Message (CCM)
continuously.
Remote MEP ID
Maintenance association End Point Identifier for the remote
receiver
To perform Loopback/Linktrace OAM test, enter the Target MAC of the destination
and click "Send Loopback" or "Send Linktrace" button.
Target MAC
MAC Address of the destination to send OAM
loopback/linktrace packet
Linktrace TTL
Time to Live value for the loopback/linktrace packet
121
Hide quick links:
Advertisement
Table of Contents
