Testing Your; Collar - Dogtra 620NCP Owner's Manual

TESTING

TESTING YOUR

1. To activate your
the red dot on the back of the transmitter to the
red dot on the receiver/collar.
Hold the two red dots together for a moment until
the green colored LED indicator light comes on.
2. Place the test light included in the package
contents on the contact points as shown
in the diagram.
3. Turn the transmitter on by pressing the blue
button on the right side of the transmitter until the
58
COLLARS
, place
LCD screen illuminates. The LCD screen shows
the amount of battery life remaining and the LED
blinks once every 2 seconds.
4. Watch the test light as you push the "Nick" button
on the transmitter. It should light for just a
moment.
5. Watch the test light as you push the "Constant"
button on the transmitter. It should light for as
long as the button is pressed. However, as a safety
feature,the receiver/collar will automatically shut
off stimulation if the constant button is depressed
for 12 seconds or longer.
6. Turn the Rheostat Intensity Dial on the transmitter
clockwise and then counterclockwise.
The test lamp should glow brighter with higher
levels of stimulation and dimmerwith lower levels.
When you change the intensity dial, the number
on the LCD screen will change as well.
7. Pressing the "Pager" button on the front of the
transmitter causes the collar to vibrate for up to
12 seconds. The collar will reactivate when you
push the button again.
NOTE : The test light may not luminate if the
intensity level is set below level ten.
TESTING
59