Related Manuals for Dogtra 1500 NCP Series
Summary of Contents for Dogtra 1500 NCP Series
- Page 1 REMOTE CONTROLLED DOG TRAINING COLLARS OWNER’S MANUAL 1250 E. 223rd Street, Suite 119 Carson, CA 90745 Tel :(310) 522 -1800 Fax :(310) 522 - 1805 Toll Free :1-888- 811-9111 Copyright c 2006 Dogtra Company 2006- www.dogtra.com...
-
Page 2: Table Of Contents
CONTENTS MAIN FEATURES PRODUCT SAFETY AND HEALTH STATEMENTS COLLAR PACKAGE CONTENTS DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF COLLAR / RECEIVER PARTS BATTERY CHARGER CHARGING THE BATTERIES TESTING YOUR COLLAR OPERATING INSTRUCTIONS ACCESSORIES WARRANTY AND REPAIR INFORMATION... -
Page 3: Main Features
1/2- Dogs should be in good health during any e-collar mile range. training. Dogtra e-collars are not intended for use on dogs weighing less than 12 pounds or under 6 months Two-dog models allow the trainer to control of age. -
Page 4: Collar Package Contents
They are Transmitter not intended for human use or use on other animals. Dogtra Company does not assume any liability for improper use of the Dogtra e-collar. Receiver (two collar receivers for two-dog models) -
Page 5: Description Of Transmitter Parts
TRANSMITTER TRANSMITTER DESCRIPTION OF TRANSMITTER PARTS transmitter 2 Antenna Antenna Transmitter Antenna Intensity Selection Dial A short 2 antenna is supplied with the Selector or Toggle Indicator Light transmitter. Switch “Nick” Button “Pager” Button The antenna should be screwed into the top of the transmitter to ensure that the signals are “Constant”... - Page 6 TRANSMITTER TRANSMITTER TWO-DOG MODELS Intensity Selection Dial Selector or Toggle Switch (2-dog models) Intensity Selection Dial Selector or Toggle Switch on the Two-Dog Models The intensity selection dial is located on the top of the transmitter: (0) being the lowest level The two-dog models have a toggle switch and (100) being the highest.
- Page 7 TRANSMITTER TRANSMITTER Transmitter Charging Receptacle Transmitter Indicator Light (LED window) The transmitter indicator light is located near the intensity selection dial. When a button on the Transmitter Battery Charging Receptacle transmitter is pushed, the light comes on to indicate that the transmitter is being activated. Located on the side of the transmitter, the The color of the light indicates the status of receptacle is covered by a rubber plug.
-
Page 8: Button Function
BUTTON FUNCTION BUTTON FUNCTION “Nick” Button BUTTON FUNCTION When the “Nick” button is pushed the receiver emits a single, rapid pulse of electrical stimulation. “Constant” Button Pressing the “Constant” button gives continuous stimulation as long as the button is Nick pushed, for up to twelve seconds. -
Page 9: Description Of Collar / Receiver Parts
COLLAR / RECEIVER COLLAR / RECEIVER DESCRIPTION OF ON/OFF Button COLLAR / RECEIVER PARTS collar Collar strap Turning on the Collar Receiver The ON/OFF button is on the bottom of the Contact Points Battery receivers. Push and hold the button for two Charging seconds until the LED light, located on the front Receptacle... - Page 10 COLLAR / RECEIVER COLLAR / RECEIVER green = full charge, amber = medium charge red = needs charge When the “Constant” button on the transmitter is pushed, the collar indicator light will glow steadily as long as you hold the button down, for up to twelve seconds.
-
Page 11: Battery Charger
COLLAR / RECEIVER BATTERY CHARGER BATTERY CHARGER Receiver Charging Receptacle Charging Cable 120 volt Charger Wall Outlet Two-dog unit only Receiver Battery Charging Receptacle The battery charger and charging cables allow On the inside of the collar receiver, next to you to charge both the transmitter and receiver at the collar strap, is a battery charging receptacle the same time. -
Page 12: Charging The Batteries
CHARGING THE BATTERIES CHARGING THE BATTERIES CHARGING THE BATTERIES 2. Do not charge the batteries near any flammable substances. 3. Fully charge the batteries for 14 hours if the collar is to be stored without use for a period of a month or more. 4. -
Page 13: Testing Your Collar
TESTING CHARGING THE BATTERIES TESTING YOUR Battery Charging Procedure 1. Attach the charging cables to both the COLLAR transmitter and receiver(s), as shown on page 20. 2. Plug the charger into a 120-volt wall outlet or, if using the accessory field charger, plug into a cigarette lighter. -
Page 14: Operating Instructions
TESTING OPERATING 2. Watch the test light as you push the “Nick” OPERATING INSTRUCTIONS button on the transmitter. It should light for just a moment. Fitting the Collar 3. Watch the test light as you push the “Constant” button on the transmitter. It The collar strap should be adjusted so that should glow brightly. - Page 15 OPERATING OPERATING Maintenance Intensity Selection The receiver and collar strap should be To select the intensity level, start on the zero cleaned periodically with detergent and water to (0) setting. Gradually increase the level until you prevent malfunction. get a response from the dog that would be equivalent to a quick pull or jerk with a leash.
-
Page 16: Accessories
ACCESSORIES RECEPTION Reception ACCESSORIES collar has a The following items may be purchased half-mile range. Depending on the way you use separately: your transmitter, the transmitting range may vary. Hold the transmitter away from your body and avoid touching the antenna to get the European Charger greatest range. -
Page 17: Warranty And Repair Information
The Limited Lifetime Warranty will expire Dogtra unit and mail it in along with a copy of (5) years from the date a unit is discontinued in your receipt within 30 days of purchase. Or, you production by Dogtra Company. - Page 18 Dogtra Co. within the continental Send repair units to: United States. Any expedited shipping service will be at the owner’s expense. Dogtra is not responsible for loss of training time or 1250 E. 223rd Street, Suite 119...
Need help?
Do you have a question about the 1500 NCP Series and is the answer not in the manual?
Questions and answers