Table of Contents
Advertisement
4-3 Starting Cutting
Stop the spindle rotation.
P. 52, "Starting and Stopping Spindle Rotation"
For the RML-1 cutting data
For the NC code cutting data
Raising the tool.
Subsequently, perform movement along the X and Y directions. Raise the tool to a position
where the tool does not come in contact with the workpiece.
P. 48, "Moving the Tool"
62
Chapter 4 Getting Ready for and Performing Cutting
When "Selected automatically
(RMX-1/NC Code)" is selected
with the command set selection,
choose "User Coordinate Sys-
tem" with Set Origin Point.
If "RML-1" is selected with the command
set selection, only "User Coordinate
System" is selectable with the Set Origin
Point.
With "Set Origin Point", select the
workpiece coordinate system that
matches the cutting data.
Select [Set "Z Origin" here], then
click [Apply].
The Z origin has now been set.
Advertisement
Table of Contents
