Table of Contents
Advertisement
Operating Instructions
KEEP GUARDS IN PLACE and in working order.
REMOVE ADJUSTING KEYS AND WRENCHES. Form
habit of checking to see that keys and adjusting wrenches
are removed from tool before turning it on.
KEEP WORK AREA CLEAN. Cluttered areas and bench-
es invite accidents.
DON'T USE IN DANGEROUS ENVIRONMENT. Don't
use power tools in damp or wet locations, or expose them
to rain. Keep work area well lighted.
KEEP CHILDREN AWAY. All visitors should be kept safe
distance from work area.
MAKE WORKSHOP KID PROOF with padlocks, master
switches, or by removing starker keys.
DON'T FORCE TOOL. It will do the job better and safer
at the rate for which it was designed.
USE RIGHT TOOL. Don't force tool or attachment to do a
job for which it was not designed.
USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using an exten-
sion cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss of power and
overheating.
WEAR PROPER APPAREL. Do not wear loose clothing,
gloves, neckties, rings, bracelets, or other jewelry which
may get caught in moving parts. Nonslip footwear is rec-
ommended. Wear protective hair covering to contain long
hair.
USE SAFETY GLASSES, face or dust mask if cutting
or cleaning operation is dusty. Everyday eyeglasses only
have impact resistant lenses, they are NOT safety glasses.
SECURE WORK. Use clamps or a vise to hold work
when practical.
DON'T OVERREACH. Keep proper footing and balance
at all times.
MAINTAIN TOOLS WITH CARE. Keep tools sharp and
clean for best and safest performance. Follow instructions
for lubricating and changing accessories.
DISCONNECT TOOLS before servicing; when changing
accessories, such as blades, bits, cutters, and the like.
REDUCE THE RISK OF UNINTENTIONAL START-
ING. Make sure switch is in off position before plugging
in.
2
USE RECOMMENDED ACCESSORIES. Consult the
owner's manual for recommended accessories. The use of
improper accessories may cause risk of injury to persons.
NEVER STAND ON TOOL. Serious injury could occur
if the tool is tipped or if the cutting tool is unintentionally
contacted.
CHECK DAMAGED PARTS. Before further use of the
tool, a guard or other part that is damaged should be care-
fully checked to determine that it will operate properly
and perform its intended function - check for alignment of
moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its
operation. A guard or other part that is damaged should be
properly repaired or replaced.
NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF. Don't leave tool until it comes to a
complete stop.
USE POWER SUPPLY CORD WHICH IS ATTACHED
WITH PRODUCTS. Do not use other power supply cord.
Advertisement
Table of Contents
