Interface Statistics - Linksys LAPAC1750PRO User Manual

LAPAC1750PRO Access Point Software User Manual

Interface Statistics

The Interface Statistics page provides some basic information about the AP and
a real-time display of transmit and receive statistics for the Ethernet interface
on the AP, and for the VAPs on both radio interfaces All transmit and receive
statistics shown are totals since the AP was last started If you reboot the AP,
these figures indicate transmit and receive totals since the reboot
To view transmit and receive statistics, click the System Status > Interface
Statistics tab
Figure 5: Interface Statistics
Section 2: Viewing Access Point System Status
Table 7: Interface Statistics
Field Description
Interface Status Table
Interface The name of the Ethernet or VAP interface
Name (SSID) Wireless network name Also known as the SSID,
this alphanumeric key uniquely identifies a
wireless local area network
The SSID is set on the VAP tab (See
Access Point (VAP)" on page
Status Shows whether the interface is enabled (up) or
disabled (down)
MAC Address MAC address for the specified interface
The AP has a unique MAC address for each
interface Each radio has a different MAC address
for each interface on each of its two radios
VLAN ID Virtual LAN (VLAN) ID
You can use VLANs to establish multiple internal
and guest networks on the same AP
The VLAN ID is set on the VAP tab (See
Access Point (VAP)" on page
Interface Statistics Table
Total Packets Indicates total packets sent or received by this
AP
Total Bytes Indicates total bytes sent or received by this AP
Dropped Packets Indicates total number of packets sent or
received by this AP that were dropped
Dropped Bytes Indicates total number of bytes sent or received
by this AP that were dropped
Errors Indicates total errors related to sending and
receiving data on this AP
Click Refresh to refresh the information on the page
"Virtual
43)
"Virtual
43)
12