Section 4: Maintenance Of The Access Point; Maintenance - Linksys LAPAC1750PRO User Manual

LAPAC1750PRO Access Point Software User Manual
Section 4: Maintenance of the
Access Point
This section describes how to maintain the access point and see system detailed
information
•

Maintenance

• Diagnostics
Maintenance
From the access point Administrator UI, you can perform the following
maintenance tasks:
Firmware
• Switching Firmware Image
• Firmware Upgrade
Configuration Backup/Restore
• Backup Configuration
•
Restoring Configuration
Reset/Reboot
•
To Restore the Factory Default Configuration
• To Reboot the Access Point
Firmware
Use this page to select the firmware image that the AP loads when it boots and
to upload a new firmware image to the device

Section 4: Maintenance of the Access Point

Figure 63: Firmware Maintenance
Table 74: Firmware Information and Management
Field Description
Active Image
Identifies the firmware images on the system:
• Active Image Firmware Version—The version number
of the image that is loaded during system boot
•
Inactive Image Firmware Version—The version
number of the inactive (backup) image on the system
Upload Method The method to use to upload a new firmware image to the
AP:
•
HTTP—Use a Web browser
• TFTP—Use a TFTP server
New Firmware
Click Browse to find and select the new firmware image
Image (HTTP located on an administrative system
Upload)
Image Filename The path and filename of the firmware image to upload
(TFTP Upload) to the AP
Server IP (TFTP The IP address of the TFTP server where the new firmware
Upload) image is located
110 110