Linksys LAPAC1750PRO User Manual page 32

LAPAC1750PRO Access Point Software User Manual
VLAN Tagging If you disable the untagged VLAN, all traffic is tagged with
a VLAN ID
By default all traffic on the access point uses VLAN 1, which
is the default untagged VLAN This means that all traffic is
untagged until you disable the untagged VLAN, change
the untagged traffic VLAN ID, or change the VLAN ID for a
VAP or client using RADIUS
Untagged Provide a number between 1 and 4094 for the untagged
VLAN ID Traffic on the VLAN that you specify in this field
VLAN ID
will not be tagged with a VLAN ID
Connection If you select DHCP, the access point acquires its IP address,
subnet mask, DNS, and gateway information from a DHCP
Type
server
If you select Static IP, you must enter information in the
Static IP Address, Subnet Mask, and Default Gateway fields
Static IP Enter the static IP address in the text boxes This field is
disabled if you use DHCP as the connection type
Address
Subnet Mask Enter the Subnet Mask in the text boxes
Default Enter the Default Gateway in the text boxes
Gateway
DNS Name Select the mode for the DNS
Servers
In Dynamic mode, the IP addresses for the DNS servers
are assigned automatically via DHCP This option is only
available if you specified DHCP for the Connection Type
In Manual mode, you must assign static IP addresses to
resolve domain names
NOTE:
After you configure the wired settings, you must click Save to apply the
changes and save the changes to startup configuration file Changing
some settings might cause the AP to stop and restart system processes
If this happens, wireless clients will temporarily lose connectivity We
recommend that you change AP settings when WLAN traffic is low
Section 3: Configuring the Access Point
IPv6 Address
The IPv6 Address page contains settings that allow the LAPAC1750PRO Access
Point to be managed over an IPv6 network Use this page to configure the IPv6
management interface settings
By default, the DHCPv6 client on the access point automatically broadcasts
requests for network information If you want to use a static IPv6 address, you
must disable the DHCPv6 client and manually configure the Static IPv6 address
and other network information
To configure the settings that allow system management over an IPv6 network,
click the Configuration > LAN > IPv6 Address tab
Figure 23: IPv6 Address
30