Samsung ML32E User Manual page 84

Chapter 5. Menu
Problem Possible Solution
The message • You cannot use the remote control when you are
"Disconnecting configuring Anynet+ or switching to a view mode.
Anynet+ device ..." • Use the remote control after the product has
appears on the screen. completed Anynet+ configuration or has finished
switching to Anynet+.
The Anynet+ device • You cannot use the play function when initial setup is in
does not play. progress.
The connected device • Check whether or not the device supports Anynet+
is not displayed. functions.
• Check whether or not the HDMI cable is properly
connected.
• Check whether
System
• Search Anynet+ devices again.
• Anynet+ requires an HDMI connection. Make sure
the device is connected to your product with an HDMI
cable.
• Some HDMI cables may not support Anynet+ functions.
• If the connection is terminated because there has
been a power failure or the HDMI cable has been
disconnected, please repeat the device scan.
Anynet+ (HDMI-CEC) is set to On
menu.
in the
84