Samsung ML32E User Manual page 74

Chapter 5. Menu
Automatic Network Settings (Wired)
Connect to the network using a LAN cable.
Make sure a LAN cable is connected first.
How to set up automatically
1 Set Network type to Wired from the
2 Press the Connect button to start Network
‒ The Connect button is only enabled when the LAN cable is properly connected.
3 The network test screen appears and verifies the network connection.
When the connection has been verified, the
connection completed." message appears.
• If the connection process fails, check the LAN port connection.
• If the automatic process cannot find the network connection values or if you want to
set the connection manually, go to the next section, network setup.
Manual Network Settings (Wired)
Offices may use static IP addresses.
If this is the case, ask the network administrator for the IP address, subnet mask,
gateway and DNS server address. Enter these values manually.
Getting the Network Connection Values
To view the Network connection values on most Windows computers, follow these
steps.
1 Right click the Network icon on the bottom right of the screen.
2 In the pop-up menu that appears, click Status.
3 On the dialog that appears, click the
4 On the Support Tab, click the Details
displayed.
How to set up manually
1 Set Network type to Wired from the
2 Press the Connect button to start Network
‒ The Connect button is only enabled when the LAN cable is properly connected.
Network Settings page.
Settings.
"Wired network and Internet
Support tab.
button. The Network connection values are
Network Settings page.
Settings.
3 The network test screen appears and the verification process starts. Press Stop.
The verification process stops.
4 Select IP Settings on network connection screen. The
5 Select the field at the top, press
Repeat the entry process for each field in the
‒ Setting IP Settings to Enter manually
Enter manually.
6 When done, select OK at the bottom of the page, and then press
test screen appears and the verification process starts.
7 When the connection has been verified, the
connection completed." message appears.
IP Settings screen appears.
, and then set IP Settings to Enter manually.
IP Address.
automatically changes DNS Setting
. The network
"Wired network and Internet
74
to