Table of Contents
Advertisement
192 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Enabling And Disabling ParkSense
ParkSense can be enabled and disabled using the Uconnect
System. The available choices are: Off, Sound Only, or
Sound and Display. Refer to "Uconnect Settings" in "Un-
derstanding Your Instrument Panel" for further informa-
tion.
When the ParkSense button is pushed to disable the
system, the instrument cluster display will show the
"PARK ASSIST SYSTEM OFF" message for approximately
five seconds. Refer to "Instrument Cluster Display" in
"Understanding Your Instrument Panel" for further infor-
mation. When the gear selector is moved to REVERSE and
the system is disabled, the instrument cluster display will
show the "PARK ASSIST SYSTEM OFF" message for as
long as the vehicle is in REVERSE.
Service The ParkSense Rear Park Assist System
During vehicle start up, when the ParkSense Rear Park
Assist system has detected a fault condition, the instru-
ment cluster display will actuate a single chime, once per
ignition cycle, and it will display the "CLEAN PARK
ASSIST", "SERVICE PARK ASSIST", or "SERVICE PARK
ASSIST SYSTEM" message. Refer to "Instrument Cluster
Display" in "Understanding Your Instrument Panel" for
further information. When the gear selector is moved to
REVERSE and the system has detected a fault condition,
the instrument cluster display will show the CLEAN
PARK ASSIST , SERVICE PARK ASSIST , OR SERVICE
PARK ASSIST SYSTEM messages for as long as the vehicle
is in REVERSE. Under this condition, ParkSense will not
operate.
If "CLEAN PARK ASSIST" appears in the instrument
cluster display, make sure the outer surface and the under-
side of the rear fascia/bumper are clean and clear of snow,
ice, mud, dirt or other obstruction. Then, cycle the ignition.
If the message continues to appear, see an authorized
dealer.
If "SERVICE PARK ASSIST" or "SERVICE PARK ASSIST
SYSTEM" appears in the instrument cluster display, see an
authorized dealer.
Cleaning The ParkSense System
Clean the ParkSense sensors with water, car wash soap and
a soft cloth. Do not use rough or hard cloths. Do not scratch
or poke the sensors. Otherwise, you could damage the
sensors.
Advertisement
Chapters
Table of Contents
